Please title this page. (Lagowski

Don Garret & Jim Lagowski - TR-1 Construction

Note: Some of these sections are large with quite a few photos. They may take an extend time to load. Please be patient.
Fuselage	Fuselage 2	Engine / Firewall	Flaps
Ailerons	Horz Stabilizer 1	Horz Stabilizer 2	Landing Gear
Rudder/VertStab	Elevator 1	Elevator 2	MAIN
Controls	Wiring Conduit	Windows/Windshield	Cowling
Doors	Engine Baffle	Instrument Panel	Wheel Fairings
Wings	Wings 2	Wings 3	Wings 4
Moving Workshops	In The Beginning	Pre-Finish +	Fuselage Dolly

Rudder / Vertical Stabilizer

Elevator and initial layout of rudder.
Trial fit of both sides of rudder.

Glassing inside of rudder.
Rudder Close out.

Fitting Ribs with light inside & other skin on. Look
down from the top to check clearances.
Communications Antenna Installed.

Hope it WORKS!

Tail screwed on. Used 2 bolts thru vertical to
clamp together while flox setup.

January 2000 Updates

Rudder Cable Connection 1St coat of Primer. We are paint-
int the completed aft end so we
can put it into the cold part of the
garage. Front 1/2 will be in the
workroom for panel, engine, etc. Second Coat of PolyFiber Primer

After starting with Polyfiber primer
they have changed to a combined
primer / UV combination.

Elevator and initial layout of rudder.	Trial fit of both sides of rudder.
Glassing inside of rudder.	Rudder Close out.
Fitting Ribs with light inside & other skin on. Look down from the top to check clearances.	Communications Antenna Installed. Hope it WORKS!
Tail screwed on. Used 2 bolts thru vertical to clamp together while flox setup.	Communications Antenna Installed. Hope it WORKS!


Rudder Cable Connection	1St coat of Primer. We are paint- int the completed aft end so we can put it into the cold part of the garage. Front 1/2 will be in the workroom for panel, engine, etc.	Second Coat of PolyFiber Primer After starting with Polyfiber primer they have changed to a combined primer / UV combination.